Select Page

SET UP IMAGE-LINE FOR ESSB RADIO

SET UP IMAGE-LINE FOR ESSB RADIO
SET UP IMAGE-LINE FOR ESSB RADIO

 

This article will focus on setting up an image-line under ESSB Radio.

Set up an ASIO4ALL sound driver, or if you have a sound card from Creative, then the Driver of the Creative SB’s Series ASIO Device. These are the most important settings for getting a high quality signal. I note that the driver should only be ASIO.

Once installed Fl Studio you need to adjust the audio options. To do this, you need to go to options (OPTIONS) and choose – set up audio (Audio settings), as shown in the picture below.

SET UP IMAGE-LINE FOR ESSB RADIO

Next, a window of settings where you need to select in the Tab Input /output driver Asio4All or Creative SB’ Series ASIO

SET UP IMAGE-LINE FOR ESSB RADIO

Next on the ASIO property tab. Now you need to go to the settings of the driver Asio4All or Creative SB’ Series ASIO, and to do this you need to click on the Show ASIO panel.

The picture below shows my settings, all the most important is highlighted by red lines. You should have the same. If you’re unlucky and don’t have the iron from Creative and mean there’s no Creative SB’s ASIO Sound Driver, I’ll tell you how to use the asio4All sound driver. But I want to say that it works worse than the Creative SB’ Series ASIO.

Do everything as in my picture that under this text and you will be a joy.

SET UP IMAGE-LINE FOR ESSB RADIO

In Asio4All settings, we can turn the device on and off and increase or reduce the buffer size. The size of the buffer is adjusted when the sound during processing begins to wheeze and stutter. This means that you do not have enough resource system in real time and then, you can increase the buffer (include in the work of the software), but it will affect the duration of the delay of the signal, but it is not terrible. If you still have the underruns in the sound after you add the buffer to the maximum, it means that your computer is out of date (to landfill and buy a new one), or it is due to other technical faults. To increase the memory buffer, move the slider to the right in the picture below, where it says the size of the ASIO buffer.

SET UP IMAGE-LINE FOR ESSB RADIO

Loading the station’s DAW system and how to minimise downloads.

I use plugins that heavily load the system but they both give me the result that I wanted to get. I’ll explain how to reduce the load on the DAW station so you don’t have sound artifacts.

The picture below shows the percentage of the load of my DAW station, also shows that my list of Channel rask (Rack channel has tools that create sound and internal generators) is completely clean and empty, because if the generators are loaded here you will increase the load on the system, and we do not need them to handle the voice.

SET UP IMAGE-LINE FOR ESSB RADIO

We don’t need to access other settings because we don’t need to use it to operate THE STATION’s DAW mode.

About The Author

Leave a reply